How we got the job done To obtain the data

How we got the job done To bind the data that we needed to do this assignment we had to use some(prenominal) different as well asls or materials. To pee-pee with you will need: bowed trained instrument of different sizes, a ruler, I recomm sack a quantity stick with centi beatnik measurements, heterogeneous loads not to large, a stopwatch, and a protractor to measure your bounty. To inauguration out we got all of the materials that are needed. Next we tide our strength train at the duration of 92cm to the light fixture above. thus we added a 20g weight to the end which is the bob. Then we swung it from the premium of 50 degrees recording how many an(prenominal) cycles it makes in ten seconds. After that we appraise it by 6 to gamble the frequency. We then did the same 2 other time changing the pot of the bob to 200g and 500g. That was the mass test. Secondly we did the length test. To do this we measured a concatenation out to 1 meter and with a 500g weight and the amplitude of 50 degrees timed it over once again for ten seconds then measureing it by six for the frequency.

over again we did this two more clock shortening the length of the string to 70cm then 50cm. Finally we did the amplitude test. With the mass of 500g and the length of 50cm we tried and true the amplitude. Starting with the amplitude of 80 degrees we again timed the sum of cycles in ten seconds. We did so two more multiplication lowering the amplitude too 70 then equal up to 60 degrees. If you exigency to get a proficient essay, golf-club it on our website: Orderessay

If you want to get a full information about our service, visit our page: How it works.